Rated 4.9 (173 reviews)
The LTECH 16-channel DMX LED Driver takes a DMX signal and drives sixteen 3A outputs, so a single unit can run a large multi-channel LED installation from your lighting desk. It runs from a 12-24 V DC supply and accepts DMX on 5-pin XLR, RJ45 or terminals.
Setup is done on the unit itself: the OLED display shows the DMX address, PWM frequency, mode (Dim, CT, RGB, RGBW), grey level and dimming curve, and the control buttons adjust them. RDM is on board, so the same settings can be changed from an RDM master console. Built-in circuit protection and photoelectric isolation help keep the install reliable.
16x 3A
Outputs
12-24 V DC
Power supply
DMX / RDM
Control
OLED
Display
Indoor use onlyRated IP20 (indoor use only), so mount it in a dry enclosure or plant room rather than outdoors.
Features
16 output channels at 3A each
DMX ports on 5-pin XLR, RJ45 and terminals
RDM on board for setup from an RDM master console
OLED display and control buttons for on-unit setup
Modes: Dim, CT, RGB, RGBW
8-bit/16-bit
Multiple dimming curve options
Built-in circuit protection and photoelectric isolation
Specifications
| Control mode | DMX / RDM |
| Display | OLED |
| Bluetooth | No |
| Power supply | 12-24 V DC |
| Power connector in | Open End |
| Power connector out | Open End |
| Dimensions (L x H x W) | 180 x 122 x 39 mm |
| Weight | 0.73 kg |
| IP rating | IP20 (indoor use only) |
| Colour | Black |
| Maximum ambient temperature | 65 °C |
| Minimum ambient temperature | -30 °C |
