Ramps & Matting

Floor-level cable protection from Elumen8: modular CP-series ramps from single-channel up to five-channel, replacement lids in yellow and black, 30 degree corner sections, end terminals and hinge rod spares, plus a 10m rubber cable ramp for lighter duties.

Channel count and channel size drive the choice: a couple of 16A leads need far less than a loom of multicore and feeder cable, so size the ramp to the fattest crossing on the run rather than the average. The modular CP ramps are the answer where vehicles cross cable routes, while the rubber roll suits pedestrian areas and quick-deploy corridors. Lid colour is a genuine decision rather than cosmetics, with yellow lids marking crossings where you want them seen and black lids keeping ramps discreet on camera or across a stage apron. Corner sections and end terminals finish a run properly, taking out the trip edges that a bare ramp end leaves behind.

Spares matter with ramps that live outdoors and get driven over, which is why lids, hinge rods and end pieces are listed individually here.

Cable Ramp FAQs

Which ramp size do I need? Count and size the cables crossing the walkway: a couple of 16A leads need a small channel; a loom of multicore and feeder wants the five-channel CP units. Corners and end terminals finish a run properly.

Rubber ramp or modular? The 10 m rubber ramp covers light-duty pedestrian runs fast; modular CP ramps take vehicles and heavy traffic, with replacement lids when years of load-ins win.